6 optional block skip, Function, Erasing the “/” character – HEIDENHAIN iTNC 530 (340 49x-03) ISO programming User Manual
Page 574: 6 op tion al bloc k skip 12.6 optional block skip
Advertising
574
12 Test Run and Program Run
12.6 Op
tion
al Bloc
k Skip
12.6 Optional Block Skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
8
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
8
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Erasing the “/” character
8
In the Programming and Editing mode you select the block in which
the character is to be erased.
8
Erase the “/” character.
This function does not work for G99 blocks.
After a power interruption the control returns to the most
recently selected setting.
Advertising