Highlighting nc blocks in the graphics, Block number display on/off, Erasing the graphic – HEIDENHAIN iTNC 530 (340 49x-04) User Manual
Page 156: 6 3-d line gr aphics (fcl 2 f unction)
156
4 Programming: Fundamentals of NC, File Management, Programming Aids, Pallet Management
4.6 3-D Line Gr
aphics (FCL
2
F
unction)
Highlighting NC blocks in the graphics
Shift the soft-key row.
To highlight the NC block selected in the left window
in the 3-D line graphics in the right window, set the
MARK THIS ELEMENT OFF / ON soft key to ON.
To not highlight the NC block selected in the left
window in the 3-D line graphics in the right window,
set the MARK THIS ELEMENT OFF / ON soft key to
OFF.
Block number display ON/OFF
Shift the soft-key row.
To show block numbers: Set the SHOW OMIT BLOCK
NR. soft key to SHOW.
To omit block numbers: Set the SHOW OMIT BLOCK
NR. soft key to OMIT.
Erasing the graphic
Shift the soft-key row.
Delete graphic: Press CLEAR GRAPHICS soft key.