HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 15)

HEIDENHAIN iTNC 530 15
Ne
w Cy
cl
e F
u
nc
tions of Sof
tw
a
re
340 49x
-07 and 606 42x
-02
New Cycle Functions of Software
340 49x-07 and 606 42x-02
„ New Cycle 225 Engraving (see “ENGRAVING (Cycle 225, DIN/ISO:
G225)” on page 315)
„ New Cycle 276 3-D Contour Train (see “THREE-D CONTOUR
TRAIN (Cycle 276, DIN/ISO: G276)” on page 213)
„ New Cycle 290 Interpolation Turning (see “INTERPOLATION
TURNING (Software Option, Cycle 290, DIN/ISO: G290)” on page
318)
„ For the thread milling cycles (Cycles 26x), a separate feed rate is
now available for tangential approach to the thread (see the
respective description of cycle parameters)
„ The following improvements were made to the KinematicsOpt
cycles:
„ New and faster optimization algorithm
„ After angle optimization, a separate measurement series is no
longer required for position optimization (see “Various modes
(Q406)” on page 490)
„ Return of offset errors (change of machine datum) in the
parameters Q147-149 (see “Cycle run” on page 478)
„ Up to eight plane measuring points for the measurement of
spheres (see “Cycle parameters” on page 487)
„ Rotary axes that are not configured are ignored by the TNC during
the execution of the cycle (see “Please note while programming:”
on page 486)