HEIDENHAIN 530 (340 49x-07) Cycle programming - Manual (Page 17)

HEIDENHAIN iTNC 530 17
Chang
e
d Cy
cle F
u
nctions of Sof
tw
a
re
340 49x
-05
Changed Cycle Functions of
Software 340 49x-05
„ The cylindrical surface cycles 27, 28, 29 and 39 can now also be
used with modulo rotary axes. In the past, MP810.x = 0 was
required.
„ Cycle 403 does not check whether touch points and compensation
axis match. As a result, probing is also possible in a tilted coordinate
system (see “BASIC ROTATION Compensation via Rotary Axis
(Cycle 403, DIN/ISO: G403)” on page 343)