HEIDENHAIN iTNC 530 (606 42x-01) User Manual
Page 412
412
Programming: Special Functions
1
1
.6 A
d
aptiv
e
F
e
ed Contr
o
l Sof
tw
a
re
Option (AFC)
Proceed as follows to select and, if required, edit the
<name>.H.AFC.DEP
file:
U
Select the Program Run, Full Sequence operating
mode
U
Shift the soft-key row
U
Select the table of AFC settings.
U
Make optimizations if required
You can also edit the <name>.H.AFC.DEP file in the Programming and
Editing mode of operation. If necessary, you can even delete a
machining step (entire line) there.
Note that the <name>.H.AFC.DEP file is locked against
editing as long as the NC program <name>.H is running. The
TNC then displays the data in the table in red.
The TNC removes the editing lock if one of the following
functions has been executed:
M02
M30
END PGM
In order to edit the <name>.H.AFC.DEP file, you must first
set the file manager so that the TNC can display
dependent files (see “Configuring PGM MGT” on page
631).