Center line as datum, 9 d a tu m set ting with a 3-d t o uc h pr obe – HEIDENHAIN iTNC 530 (606 42x-01) User Manual
Page 565
HEIDENHAIN iTNC 530
565
14.9 D
a
tu
m Set
ting with a 3-D T
o
uc
h Pr
obe
Center line as datum
U
Select the probe function by pressing the PROBING
soft key.
U
Position the touch probe at a position near the first
touch point.
U
Select the probing direction by soft key.
U
To probe the workpiece, press the machine START
button.
U
Position the touch probe at a position near the second
touch point.
U
To probe the workpiece, press the machine START
button.
U
Datum:
Enter the coordinate of the datum in the menu
window, confirm with the SET DATUM soft key, or
write the value to a table (see "Writing the measured
values from touch probe cycles in datum tables", page
550, or see "Writing the measured values from touch
probe cycles in the preset table", page 551, or see
"Storing measured values in the pallet preset table",
page 552.)
U
To terminate the probe function, press the END key.
X
Y
X+
X
X
Y
X
X+