HEIDENHAIN TNC 640 (34059x-02) Cycle programming - Manual (Page 22)

Contents
22
TNC 640 | User's Manual Cycle Programming | 5/2013
7.9 CONTOUR TRAIN (Cycle 25, DIN/ISO: G125).................................................................................... 193
Cycle run.................................................................................................................................................193
Please note while programming:........................................................................................................... 193
Cycle parameters................................................................................................................................... 194
7.10 Programming Examples...................................................................................................................... 195
Example: Roughing-out and fine-roughing a pocket.............................................................................. 195
Example: Pilot drilling, roughing-out and finishing overlapping contours............................................... 197
Example: Contour train.......................................................................................................................... 199