HEIDENHAIN TNC 640 (34059x-02) Cycle programming - Manual (Page 43)

TNC 640 | User's Manual Cycle Programming | 5/2013
43
20 Touch Probe Cycles: Automatic Tool Measurement....................................................................557
20.1 Fundamentals....................................................................................................................................... 558
Overview................................................................................................................................................ 558
Differences between Cycles 31 to 33 and Cycles 481 to 483.............................................................. 559
Setting machine parameters.................................................................................................................. 560
Entries in the tool table TOOL.T............................................................................................................562
20.2 Calibrate the TT (Cycle 30 or 480, DIN/ISO: G480)........................................................................... 564
Cycle run.................................................................................................................................................564
Please note while programming:........................................................................................................... 564
Cycle parameters................................................................................................................................... 564
20.3 Calibrating the wireless TT 449 (Cycle 484, DIN/ISO: G484)........................................................... 565
Fundamentals......................................................................................................................................... 565
Cycle run.................................................................................................................................................565
Please note while programming:........................................................................................................... 565
Cycle parameters................................................................................................................................... 565
20.4 Measuring tool length (Cycle 31 or 481, DIN/ISO: G481).................................................................566
Cycle run.................................................................................................................................................566
Please note while programming:........................................................................................................... 567
Cycle parameters................................................................................................................................... 567
20.5 Measuring tool radius (Cycle 32 or 482, DIN/ISO: G482)................................................................. 568
Cycle run.................................................................................................................................................568
Please note while programming:........................................................................................................... 568
Cycle parameters................................................................................................................................... 569
20.6 Measuring tool length and radius (Cycle 33 or 483, DIN/ISO: G483)..............................................570
Cycle run.................................................................................................................................................570
Please note while programming:........................................................................................................... 570
Cycle parameters................................................................................................................................... 571