HEIDENHAIN TNC 640 (34059x-02) Cycle programming - Manual (Page 47)

Available Cycle Groups 1.2
1
TNC 640 | User's Manual Cycle Programming | 5/2013
47
1.2 Available Cycle Groups
Overview of fixed cycles
The soft-key row shows the available groups of
cycles
Cycle group Soft key Page
Cycles for pecking, reaming, boring, and counterboring 70
Cycles for tapping, thread cutting and thread milling 100
Cycles for milling pockets, studs and slots 136
Cycles for producing hole patterns, such as circular or linear point patterns 166
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively
complex contours consisting of several overlapping subcontours, cylinder surface
interpolation 202
Cycles for multipass milling of flat or twisted surfaces 230
Coordinate transformation cycles which enable datum shift, rotation, mirror image,
enlarging and reducing for various contours 244
Special cycles such as dwell time, program call, oriented spindle stop and
tolerance 268
Cycles for turning operations 280
If required, switch to machine-specific fixed
cycles. These fixed cycles can be integrated by
your machine tool builder.