HEIDENHAIN TNC 640 (34059x-02) Cycle programming - Manual (Page 37)

TNC 640 | User's Manual Cycle Programming | 5/2013
37
16 Touch Probe Cycles: Automatic Datum Setting.......................................................................... 415
16.1 Fundamentals....................................................................................................................................... 416
Overview................................................................................................................................................ 416
Characteristics common to all touch probe cycles for datum setting....................................................418
16.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408)..........................................................................420
Cycle run.................................................................................................................................................420
Please note while programming:........................................................................................................... 421
Cycle parameters................................................................................................................................... 422
16.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409)........................................................................ 424
Cycle run.................................................................................................................................................424
Please note while programming:........................................................................................................... 424
Cycle parameters................................................................................................................................... 425
16.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410)............................................... 427
Cycle run.................................................................................................................................................427
Please note while programming:........................................................................................................... 428
Cycle parameters................................................................................................................................... 429
16.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411)........................................... 431
Cycle run.................................................................................................................................................431
Please note while programming:........................................................................................................... 432
Cycle parameters................................................................................................................................... 432
16.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412)....................................................... 435
Cycle run.................................................................................................................................................435
Please note while programming:........................................................................................................... 436
Cycle parameters................................................................................................................................... 437
16.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)................................................... 440
Cycle run.................................................................................................................................................440
Please note while programming:........................................................................................................... 440
Cycle parameters................................................................................................................................... 441
16.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414)................................................. 444
Cycle run.................................................................................................................................................444
Please note while programming:........................................................................................................... 445
Cycle parameters................................................................................................................................... 446