HEIDENHAIN TNC 640 (34059x-04) Cycle programming - Manual (Page 39)

TNC 640 | User's Manual Cycle Programming | 3/2014
39
16 Touch Probe Cycles: Automatic Datum Setting........................................................................ 435
16.1 Fundamentals...................................................................................................................................... 436
Overview............................................................................................................................................... 436
Characteristics common to all touch probe cycles for datum setting...................................................438
16.2 DATUM SLOT CENTER (Cycle 408, DIN/ISO: G408).........................................................................440
Cycle run............................................................................................................................................... 440
Please note while programming:.......................................................................................................... 441
Cycle parameters.................................................................................................................................. 442
16.3 DATUM RIDGE CENTER (Cycle 409, DIN/ISO: G409).......................................................................444
Cycle run............................................................................................................................................... 444
Please note while programming:.......................................................................................................... 444
Cycle parameters.................................................................................................................................. 445
16.4 DATUM FROM INSIDE OF RECTANGLE (Cycle 410, DIN/ISO: G410).............................................. 447
Cycle run............................................................................................................................................... 447
Please note while programming:.......................................................................................................... 448
Cycle parameters.................................................................................................................................. 449
16.5 DATUM FROM OUTSIDE OF RECTANGLE (Cycle 411, DIN/ISO: G411).......................................... 451
Cycle run............................................................................................................................................... 451
Please note while programming:.......................................................................................................... 451
Cycle parameters.................................................................................................................................. 452
16.6 DATUM FROM INSIDE OF CIRCLE (Cycle 412, DIN/ISO: G412)...................................................... 454
Cycle run............................................................................................................................................... 454
Please note while programming:.......................................................................................................... 455
Cycle parameters.................................................................................................................................. 456
16.7 DATUM FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413).................................................. 459
Cycle run............................................................................................................................................... 459
Please note while programming:.......................................................................................................... 459
Cycle parameters.................................................................................................................................. 460
16.8 DATUM FROM OUTSIDE OF CORNER (Cycle 414, DIN/ISO: G414)................................................463
Cycle run............................................................................................................................................... 463
Please note while programming:.......................................................................................................... 464
Cycle parameters.................................................................................................................................. 465