SMA WB 5000 Installation - Manual (Page 29)

SMA Technology AG Installation
Installation Guide WB50_60-11:SE4005 Page 29
Connecting the AC output
To connect the AC output, proceed as follows:
1. Check the grid voltage. If this is higher than 260
V, the Windy Boy 5000 / 6000 will not be fully
operational. In this case, contact the local grid
operator for assistance.
Max. 260V!
The maximum grid voltage for feeding
electricity into the grid is 260 V!
2. Isolate the grid connection (switch the line circuit
breaker to its "off" position), make sure it cannot
be switched back on, and test to make sure no
voltage is present.
You must make sure that no voltage is
present at the AC output before opening
the Windy Boy!
3. Remove the screws that secure the case of the
Windy Boy 5000 / 6000 and remove the cover.
4. Connect the earth wire (PE) of the mains cable
to the left terminal of the right terminal block
(see the figure on the right).
PE conductor connection
1. 2. 3.
Off!
Netzw echselr ichter fü r Wind energie anlage n Grid tie d inver ter for w ind turb ines
Pac 903W Upv 330V
Windy Boy
N L1 230 Vac:
PE