Table 5, Figure 7, 5 installation procedure – Yaskawa BACnet MS/TP User Manual
Page 19
Table 5 Communication Wire Routing Selection
Drive Series
Model
Wire Routing <1>
Through
Front Cover
Inside Drive
A1000
CIMR-Ao2A0004 to 0040;
CIMR-Ao4A0002 to 0023;
CIMR-Ao5A0003 to 0011
–
A1000
CIMR-Ao2A0056 and above;
CIMR-Ao4A0031 and above;
CIMR-Ao5A0023 and above
–
(B)
for examples of the different wire routing techniques.
A
B
A – Route wires through the
openings provided on the
left side of the front
cover.
<1>
B – Use the open space
provided inside the drive
to route option wiring.
Figure 7 Wire Routing Examples
<1> The drive will not meet NEMA Type 1 requirements if wiring is exposed outside the enclosure.
2.
Connect the BACnet communication cables to the option modular connector terminal
block (TB1).
Note:
Separate the communications cables from the main circuit cables and other wiring and power
cables. Use properly grounded shielded cables for the communication cables to prevent
problems caused by electrical interference.
5 Installation Procedure
YASKAWA TOEP YEACOM 08A A1000 Option BACnet MS/TP SI-B3 Installation & Technical Manual
19