Yaskawa AC Servo Drives Sigma II Series INDEXER - Manual (Page 7)

E-5
„ INSTALLATION
„ WIRING
„ OPERATION
(Ref.No.)
• Never use the equipment where it may be exposed to splashes of water, corrosive
or flammable gases, or near flammable materials.
Failure to observe this caution may result in electric shock or fire.
E-13
CAUTION
(Ref.No.)
• SERVOPACK grounding must be in accordance with the national code and consis-
tent with sound local practices.
Failure to observe this warning may result in electric shock or fire.
E-16
(Ref.No.)
• Do not connect three-phase power supply to SERVOPACK output terminals U, V,
and W.
Failure to observe this caution may result in personal injury or fire.
E-16
• Securely tighten screws on the power supply and motor output terminals.
Failure to observe this caution may result in a fire.
E-16
WARNING
CAUTION
(Ref.No.)
• To avoid inadvertent accidents, run the servomotor only in test run (without load).
Failure to observe this caution may result in personal injury.
E-18
• Before starting operation with a load connected, set up parameters suitable for the
machine.
Starting operation without setting up parameters may result in machine overrun or failure.
E-18
• Before starting operation with a load connected, make sure emergency-stop proce-
dures are in place.
Failure to observe this caution may result in personal injury.
E-18
• During operation, do not touch the SERVOPACK’s heatsink.
Failure to observe this caution may result in burns.
E-19
CAUTION