Yaskawa CM061 - Manual

Yaskawa Electric America, Inc. – www.yaskawa.com
IG.G5HHP.12 Page 1 of 9
Date: 11/06/06 Rev: 06-11
‰
This document applies to the Yaskawa G5HHP drive. Please disregard the installation guide packed in the option kit.
‰
Unpack the CM061 Profibus-DP Option kit and verify that all components are present and undamaged.
‰
Connect power to the drive and verify that the drive functions correctly. This includes running the drive from the operator keypad. Refer to the appropriate drive technical
manual for information on connecting and operating the drive.
‰
Remove power from the drive and wait for the charge lamp to be completely extinguished. Wait at least five additional minutes for the drive to be completely discharged.
Measure the DC bus voltage and verify that it is at a safe level.
‰
Attach the CM061 Profibus-DP Option (SI-P1 card) to the master control board.
„
Attach the CM061 Profibus-DP Option ground wire to the ground terminal
as shown. Make sure that the terminal is connected to a reliable, noise free
ground.
„ Connect the CM061 Profibus-DP Option card to the 2CN connector on the
master control board.
„ Secure the Profibus cable to the support with a tie wrap to provide strain
relief for the connector.
„ Attach the Profibus cable to the CM061 Profibus-DP Option card as shown
(this picture shows the standard Phoenix connector shrink-wrapped for
additional protection).
„ Fully engage the stand-offs in the mounting holes on the card.
„ Route the Profibus cable away from any power wires within the cabinet.
When outside of the cabinet, run the Profibus cable in its own conduit.
However, it may be run with low voltage signals such as feedback wiring.
Profibus-DP
®
Option Card
CM061 (SI-P1)
CM061 Profibus-DP Option Kit Parts List Qty.
Profibus-DP Option Card (SI-P1) 1
Installation Guide (IG.AFD.12) (Disregard for G5HHP) 1
Stand-offs
Attaching the CM061 Profibus-DP Option on a G5HHP master control board.
SI-P1 Card
Ground Terminal
2CN Connector
Profibus Cable
Support
SI-P1 Card