Epson 900 - Manual (Page 48)

1. Holding the memory module with the
notch on the upper right corner, align it
with the connector at the edge of the
socket.
2. Insert the memory module into the socket
at an angle, pressing along the edge until
it clicks into place.
3. Press down on the module until it snaps
into the retaining clips on the sides.
4. Replace the keyboard as described in the
previous section.
5. Run Setup, as described under
“Customizing Computer Settings” in
Chapter 6, to make sure your computer
recognizes the new memory. (When you
turn on the computer, it will warn you of
a memory size mismatch)
Upgrading Internal Components 5-13