Epson 900 - Manual (Page 55)

The table below lists the page 3 Setup options.
Setup page 3 options
Setting Options Description
Internal Enabled* Controls the processor’s
Cache Disabled internal cache operation
External Enabled* Controls the processor’s
Cache Disabled external cache operation when
external cache is installed
Serial Port 1 3F8h* Assigns the address for the
2F8h serial port on the computer or
3E8h serial port 1 on the replicator
2E8h
Disabled
Serial Port 2 3F8h Assigns the address for the
2F8h* second serial port (either the IR
3E8h device or serial port 2 on the
2E8h replicator)
Disabled
Parallel 278h* Assigns the parallel port address
Port** 378h
3BCh
Disabled
Audio 220h* Identifies the address setting
230h the audio card uses
240h
250h
Disabled
Audio IRQ 5 Identifies the IRQ setting the
7
audio card uses
9*
10
Pointing Enabled* Lets you disable the built-in
Device Disabled touchpad, in case you connect a
serial mouse
Block IDE Enabled Enables support for block mode
Disabled transfers, if your hard disk drive
supports it
Serial Port 2 IR* Lets you define the operation of
Replicator Serial Port 2
* Default setting
** Autodetects ECP or EPP devices when connected and
turned on
at
system
start-up
Customizing Your Computer 6-7