Epson 900 - Manual (Page 51)

To select a setting click the button for that
setting, then adjust the controls.
When you’ve made changes, click OK to exit.
Your settings take effect immediately.
N O T E
If you install another pointing device and
then want
to return to the ActionPoint, you need to reinstall
the ActionPoint drivers. Type the following
commands at the MS-DOS prompt:
CD\SYNTOUCH
INSTALL
Customizing Computer Settings
Setup configures your ActionNote and stores
the settings in the computer’s CMOS ROM
(read-only memory). Because this area of
memory is backed up by a battery, it is not
erased when you turn off or reset the computer.
The current configuration is probably fine for
most of your needs. However, you may need to
run Setup when you upgrade your computer
or connect new equipment. You can also run
Setup to customize power management.
Customizing Your Computer 6-3