LinPlug Octopus - Manual (Page 35)

The Time control is used for setting the chorus' delay time. Longer delay
times produce a chorusing effect while shorter times create a flanging
effect. The SPD (Speed) dial sets the rate at which the signal is modulated.
The Stereo control is used to adjust the width of the stereo image. To
create the maximum stereo effect set the control to its maximum value.
Note that when used in combination with other stereo enhancing effects
(such as the Delay) it might be desirable to set the Stereo control to a lower
value.
The Dry control allows you to set the level of the original unprocessed or dry
signal that is sent from the effects unit. This control is useful for controlling
the balance between the effect's processed and unprocessed output
signals.
The Wet control allows you to set the level of the processed or wet signal
that is sent from the effects unit. This control is useful for controlling the
balance between the effect's processed and unprocessed output signals.
The Invert control is inverts the phase of the effect's Wet signal. This can
be used to produce a different type of chorusing effect.
Delay
The Delay effect is located to the right of the Chorus effect. This effect can
be used to create echoes that bounce around the stereo field. The Delay
features controls for: TMP Sync, Time Pre, Time Left, Time Right, L, (Pan
Left), R (Pan Right), FDBK (Feedback), Bal (Balance) and Wet.
Manual 33