LinPlug Octopus - Manual (Page 36)

The Delay functions as follows: the input signal is first delayed by Time Pre
amount, then it’s delayed by Time Left amount and finally by the Time Right
amount. If Feedback is applied, the Time Right signal is fed back into the
left delay line, so that an alternating left-right delay is produced. The Bal
(Balance) and Wet controls set the mix between the original unprocessed
signal and the delayed signal.
The TMP Sync control synchronises the effect's delay times with the song's
current tempo. When the TMP Sync control is OFF the effect's delay times
are shown in milliseconds. When the TMP Sync control is ON the effect's
delay times are shown in quarter notes. In this case, the actual delay time
depends on the current song's tempo.
The Time Pre, Time Left and Time Right controls are used for setting the
centre, left and right channel delay times. The Time Pre control sets the
delay time of the centre delay while the The Time Left and Time Right
controls set the delay times of the left delay and right delay. The delay time
is displayed as either milliseconds or quarter notes depending on the
current setting of the TMP Sync control. When the TMP Sync control is OFF
all three delays have a range of 1 ms to 1300 ms. When the TMP Sync
control is ON all three delays have a range of 0.00 to 8.00 quarter notes.To
edit one of the delay times click on the numerical display and drag the
mouse up or down.
The L (Pan Left) and R (Pan Right) controls are used to set the pan position
of the Time Left and Time Right delay signals.
Hint: If you want the delayed signal to appear on the right side first, use the
Pan controls to exchange left and right positions.
The FDBK (Feedback) control sets the number of times the signal repeats
or echoes.
The Bal (Balance) control is used to set the balance between the pre delay
and the left and right delays. Turning the Bal control completely anti-
clockwise means that only the Time Pre delay signal is sent from the effects
34 Manual