LinPlug RMV - Manual (Page 91)

Signal Path
Insert Effects
The RMV's Insert Effects section is located on the lower left of the instrument's Pad Panel,
and on the lower right of the instrument's Loop Panel. Three independent stereo Effects
Racks are available for each Pad: Effects Rack 1, Effects Rack 2 and Effects Rack 3. All
three Effects Racks are identical.
Each of the RMV's three Effects Racks can be set to one of nine Effects Units. These are:
Delay, Ping Pong, Flanger, Filter, Reverb, Gator, WahWah, Compressor and Crusher. To
select an Effects Rack, use the Selection buttons labelled “1”, “2” and “3” at the left of the
Insert Effects section. To set the Effects Unit for a particular Effects Rack, click on the
Effect Name located above the Insert Effects section. This opens a popup menu displaying
the available Effects Units. Select one of the Effects Units in the popup menu to place it in
the Effects Rack.
All effects modules can be set to either "On" or "Thru" using the Power button to the left of
the Effect Type menu, or by using the three Power buttons to the right of the Selection
buttons. Note that only one Insert Effects Unit is displayed at a time. To switch between the
three Effects Racks, click on the Selection buttons labelled “1”, “2”, and “3” at the left of the
Insert Effects section.
Each Effect Unit's controls differ. All Effects Units are described in detail below.
LinPlug Reference Manual 5.0.1 91