Edelbrock 3550 - Manual (Page 17)

17
Pro-Flo EFI Installation Instructions
©2005 Edelbrock Corporation
Brochure No. 63-0115 Rev. 10/05
CONNECTORS
The “J” coding is for illustration purpose only. The connector ends DO NOT have a “J” code stamped on them
J1 ECU
J2 Calibration module
J3 Pump harness
J8 Throttle Position Sensor
J9 Manifold Absolute Pressure sensor
J10 Coolant Temperature sensor
J11 Manifold Air Temperature sensor
J12 Distributor
J13 Injector, number 1 cylinder
J14 Injector, number 3 cylinder
J15 Injector, number 5 cylinder
J16 Injector, number 7 cylinder
J17 Injector, number 2 cylinder
J18 Injector, number 4 cylinder
J19 Injector, number 6 cylinder
J20 Injector, number 8 cylinder
INSTALLATION
1. Inspect the Main System Harness, making sure that all connectors and
grounds are properly in place.
2. Because the harness extends from the engine compartment into the
passenger compartment, a hole must be drilled in the firewall on the
passenger side. Cut two overlapping 1 1/4-inch holes on a 1-inch center in
the firewall. Saw the pointed edges to create an oval-shaped hole.
NOTE: An alternative to this method is to cut a single 1 3/4 inch hole.
3. Extend the fuel pump relay, ECU connector, and Calibration Module relay
through the firewall hole into the passenger compartment.
NOTE: The T-connectors at the joints of the Main System Harness are closed
by snap fasteners which can be opened by hand or with a flathead
screwdriver. Once open, the T-connectors can be rotated for ease of
installation, if necessary.
4. The 3 1/2 x 2 1/4-inch aluminum plate included on the harness mounts over the firewall hole using four hex head sheet metal screws.
NOTE: Start the screw holes with a pointed punch or small drill.
5. The wire harness is assembled with the aluminum plate flush against a T-connector. The black plastic casing on the wire harness can be
cut to allow the plate to slide up the harness to the correct location. Once the harness is in place, the casing should be reattached on both
sides of the firewall.
CAUTION: When feeding the wire harness through the firewall, be careful to not damage the wires against the cut sheet metal.
6. A rubber grommet is provided to protect the wires in the aluminum plate. Use RTV to seal the plate to the firewall.
7. Install all connectors according to the list and diagrams. The harness has been designed so that each connector is unique and will fit only to
its correct match. There is only one possible installation combination; it cannot be installed incorrectly.
J26 Ignition amplifier
J27 IAC connector
P27 IAC connector to main harness
RT1 Engine ground
RT3 Starter J21 Oxygen sensor
J22 Connector to IAC
J23 Relay
J24 ECU fuse
J25 Pump fuse