Edelbrock 3550 - Manual (Page 3)

3
Pro-Flo EFI Installation Instructions
©2005 Edelbrock Corporation
Brochure No. 63-0115 Rev. 10/05
TOOLS AND EQUIPMENT
Use the following checklist for items needed.
❑
Box and open end wrenches
❑ Socket set
❑ Distributor wrench
❑ Pliers (channel locks and hose clamp)
❑ Screwdrivers (regular and Phillips)
❑ Torque wrench
❑ Hammer
❑ Gasket scraper or putty knife
❑ Timing light
❑ Vacuum gauge
❑ Rags
❑ Water bucket
❑ Drill and bits
❑ Hole saw (1 1/4-inch or 1 3/4-inch)
❑ Tubing wrenches
❑ Tubing cutter
PRELIMINARY CHECKLIST
1. CAREFULLY STUDY AND UNDERSTAND ALL INSTRUCTIONS, BEFORE BEGINNING THIS INSTALLATION.
NOTE: This installation can be accomplished using common tools and procedures. However, you should have a basic
knowledge of automotive repair and modification and be familiar with and comfortable working on your vehicle. If you do
not feel comfortable working on your vehicle, it is recommended to have the installation completed by a professional
mechanic.
2. Examine the Pro-Flo system for possible shipping damage. If damaged, contact your dealer immediately.
3. The 3550 & 3551 kits are designed for use with a standard Big Block Chevy V8 firing order.
4. Check all threaded manifold holes.
5. Check all internal manifold passages with a light and wire, making sure they are clean and unobstructed.
6. Check automatic transmission shift points before removal of your stock manifold and adjust linkage after Edelbrock
manifold installation for same shift points (if needed).
NOTE: We recommend that you refer to this checklist again after installation to be sure that you have completed all steps.
HARDWARE AND PARTS RECOMMENDED
Use the following checklist for items needed.
❑
Intake gasket - Edelbrock #7203, OEM, or equivalent
❑ Pipe plugs, if needed
❑ 5/16-inch steel tubing (approximate equal length to fuel pickup
line in tank)
❑ Edelbrock Gasgacinch #9300
❑ Loctite 598 OEM High Temperature Silicone Gasket (O
2
Sensor
Compatible)
❑ Radiator coolant
❑ Wiring diagram for your vehicle
❑ Teflon tape or liquid Teflon thread sealer
❑ Manifold bolt kit #8564
❑ Throttle, Cruise Control & Trans. Kick-Down Mounting Bracket
#8031 (If Necessary see general catalog)
❑ 195° Thermostat
❑ Resistor type spark plugs (Use correct heat range for your
particular application
❑ Set of low-resistance spark plug wires with high EMI suppression
(DO NOT use solid core spark plug wires)