Casio XJ-460 Basic Operations - Manual (Page 13)

E-13
General Guide
En
gl
is
h
Before you can use the remote controller for the first time, you need to load the two batteries
that come with it.
z Be sure to use alkaline batteries only.
This wireless remote control unit is a Class II laser product (max. output: 1mW ; wave length:
650nm).
z Holding down the [LASER] key causes a red laser beam to be emitted from the front edge
of the remote controller. Use the laser beam to point to the object you want to indicate in
the image.
z The [AF/AK] key lights red while this key is depressed to indicate that the laser beam is
being emitted.
Loading Remote Controller Batteries
Caution
Misuse of batteries can cause them to leak and stain of the area around
them, or to explode, creating the risk of fire and personal injury. Make sure
that you always observe the following precautions.
z Take care that batteries are oriented correctly when you load them.
z Never mix old batteries and new ones.
z Never mix batteries of different types.
z Use only battery type that is specified for use with the remote controller.
1.
Remove the battery cover from the
back of the remote controller.
2.
Load two new batteries into the case,
making sure that their positive (+) and
negative (–) ends are facing correctly.
3.
Replace the battery cover on the back of the remote controller.
Using the Laser Pointer
Warning
z Never look directly at the laser beam. Doing so creates the risk of eye
damage and loss of sight.
z Never point the laser beam at another person. Shining the laser beam into
the eyes of another creates the risk of eye damage and loss of sight.
z Keep the remote controller out of the reach of young children, and never
allow a young child to operate the remote controller.
Caution
z Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.