Casio XJ-460 Basic Operations - Manual (Page 16)

Getting Ready
E-16
You can change the elevation angle of the projector in a range of 0 to 8 degrees. You can
also make fine adjustments to the left and right side elevation angle when necessary.
To change the projector elevation angle
1.
Lift up the front of the projector and press the
release button.
z This causes the elevation adjustment foot to drop
from the bottom of the projector.
2.
While holding down the release button, raise and
lower the front of the projector until the elevation
adjustment foot is approximately the length you
need.
3.
Release the release button to lock the elevation adjustment foot in its current position.
4.
Rotate the elevation adjustment foot for fine adjustment of its length.
5.
Use the left and right adjustment feet to further fine adjust the elevation angle.
z To retract the elevation adjustment foot, hold down the release button and slide the
elevation adjustment foot back into the projector. Never try to forcibly change the elevation
adjustment foot position without pressing the release button.
In the case of rear projection, left/right orientation is opposite that of front projection, so you
need to configure the setup menu accordingly. For more detailed operation information, see the
User’s Guide (UsersGuide_English.pdf) on the CD-ROM that comes with the projector.
Adjusting the Projector Elevation Angle
Rear Projection (From the Back of the Screen)
Shorter Longer
Rotate to adjust horizontal alignment.