Extron Electronics MAV Plus Series - Manual (Page 119)

Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide 4-12
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
I/O Grouping (Continued)
Read output grouping Esc O X10
1
X10
2
X10
3 … X10
n One X10 entry for each output,
starting from input 1, n is the
maximum number of inputs for
this model.
The group that is assigned ( X10 ) must be 1, 2, 3, 4, or 0 (not grouped).
Save, recall, and directly write presets
• If the user tries to recall a preset that is not saved, the matrix switcher responds with the
error code E11.
• If the room is nonexistent, the matrix switcher responds with the error code E21.
• The following characters are invalid in preset names:
+ ~ , @ = ‘ [ ] { } < > ’ “ ; : | \ and ?.
Save current ties as a global preset X11
,
Spr X11 Command character is a comma.
Example: 9
,
Spr09 Save current ties as preset 9.
Recall a global preset X11
.
Rpr X11 Command character is a period.
Example: 5
.
Rpr05 Recall preset 5, which becomes
the current configuration.
Save current ties for a room X8 * X12
,
Rmm X8 •Spr X12 Command character is a comma.
Example: 3*9
,
Rmm03•Spr09 Save current ties as preset 9 for
room 3.
Direct write process —
The direct write of a global preset should always be preceded by a clear global preset
command of that same preset number, as shown below. In a directly-written preset, each output
position’s tied input (or no tied input) remains unchanged unless overwritten or cleared.
If you do not clear a global preset number before you directly write a global preset to that
number, ties that are part of the previous version of the specified presets with the same number
can unexpectedly become part of the newly-created preset.
Clear a global preset Esc + X11 P0*! Spr X11 Clear all ties in preset number X11 .
Directly write a global preset Esc + X11 P X2 * X3 ! X2 * X3 % X2 * X3 $… X2 * X3 & The tie all (!), tie RGBHV (&),
Spr X11 tie video (%), and tie audio ($)
commands are all valid.
Example: +27P2*5!10*9$13*11%3*10& Esc Brackets are shown to separate
Spr27 ties for clarity only. Create global
preset 27, which ties video and
audio input 22 to output 5,
RGBHV input 15 to output 29,
video input 13 to output 26, and
audio input 3 to output 8.
Write room outputs Esc X8 , Y1 , Y2 ,... Yn MR
Mpr X8 , Y1 , Y2 ,... Yn See notes.
• Each Y# is an output
• A room can contain a maximum of 16 outputs.
• An output can only belong to one room.
• The maximum number of rooms ( X8 )is 10.
• If no room name is assigned, the default name is “Room #
X*•Y!
,
•Y@
,
•Y#
”.
Example: Esc 8,3,04,5,6MR Mpr8,03,04,05,06 Outputs 3, 4, 5, and 6 are
assigned to room 8.