Extron Electronics MAV Plus Series - Manual (Page 73)

Operation, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Operation 3-30
2 . Press and hold the Preset button for approximately 2 seconds until it blinks
(figure 3-44).
PRESET PRESET
1 2 3 4 15 16
17 18 19 20 31 32
I
N
P
U
T
S
Press and hold the Preset button until it blinks.
2 seconds
All input buttons with assigned
presets light red.
If you then save the configuration
to a lit preset number, the configuration
data at that preset location
will be overwritten.
Red
(Preset Assigned)
Unlit
(No Preset Assigned)
Figure 3-44 — Enter Save Preset mode
3 . Press and release the input or output button for the desired preset
(figure 3-45).
1 2 3 4 5 6 7 8 15 16
17 18 19 20 21 22 23 24 31 32
I
N
P
U
T
S
C O N T R O L
PRESET ENTER ESC VIEW
•
•
• The Enter button blinks to
indicate the need to save
the preset.
The Preset button
continues to blink.
Press and release the Input 1 button.
The button blinks red to indicate that this preset
number is selected but not saved.
Figure 3-45 — Select the preset
Figure 3-42 on page 3-29 shows the presets associated with the various input
and output buttons for all three front panel configurations.
4 . Press and release the Enter button (figure 3-46). The current configuration is
now stored in the selected memory location.
C O N T R O L
PRESET ENTER ESC VIEW
The Enter and Preset
buttons return to unlit or
background illumination.
Press the Enter button to
save the preset.
All input buttons return to unlit
or background illumination.
Figure 3-46 — Press the Enter button