Extron Electronics MAV Plus Series - Manual (Page 50)

3-7 CrossPoint 450 Plus and MAV Plus Switchers • Operation
6 Esc ( ) button — The Esc ( ) button has two primary functions (•) and
eight secondary (❏) functions:
• Cancel operations or selections in progress and reset the front panel
button indicators.
The Esc ( ) button does not reset the current configuration, the RGBHV
(CrossPoint 450 Plus switchers) or Video (MAV Plus switchers) button and
Audio selection button, any presets, or any audio gain or attenuation or
volume settings.
• Flashes once to indicate that the escape function has been activated.
❏ In the I/O Group mode, select group 4. See “I/O grouping” on page 3-21.
❏ In the I/O Group mode, indicate that group 4 is selected. See “I/O
grouping” on page 3-21.
❏ (CrossPoint 450 Plus switchers) Increase the RGB delay of switches to
the selected output. See “Setting RGB delay (CrossPoint 450 Plus
Switchers)” on page 3-26.
❏ (Audio models) Increase the audio level of the selected input. See
“Viewing and adjusting the input audio level (audio models)” on
page 3-35.
❏ (Audio models) Increase the volume of the selected output. See
“Viewing and adjusting the output volume (audio models)” on page 3-41.
❏ With the Enter, Preset, and View buttons, select Serial Port Configuration
mode. See “Selecting the rear panel Remote port protocol and baud rate”
on page 3-51.
❏ Select 115200 baud for the rear panel Remote port in Serial Port
Configuration mode. See “Selecting the rear panel Remote port protocol
and baud rate” on page 3-51.
❏ Indicate that the rear panel Remote port is set to 115200 baud in Serial
Port Configuration mode. See “Selecting the rear panel Remote port
protocol and baud rate” on page 3-51.