Crivit 1-LD3292 - Manual (Page 6)


- 17 -
If the calibration was successful "KALIBR OK! SPEICH / CALI OK!
SAVE" will appear. If the calibration was unsuccessful "KALIBR.
FEHLER / CALI FAILED" will appear. In this case please repeat the
calibration process.
"KALIBR. GEHEN / CALI FOR WALKING" will now appear on the
display. Complete the calibration for walking in the same way as the
calibration for running.
The calibration can be aborted by pressing MODE.
Exit setting mode by pressing MODE.
Odometer (GESAMT-DIST/ODOMETER)
The bottom row of the display will show the total covered distance. The
value can be reset by pressing and holding SET.
Pedometer (SCHRITTE/STEP)
The bottom row of the display will show the step count. The value can
be reset by pressing and holding SET.
Calories, fat burn and BMI (KALORIEN/CALORIE)
The lower row will show the burned calories (KALORIEN/CALORIE).
Press SET to switch to the display of fat burn in gram (FETT/FAT
BURN) or to the display of your BMI (Body Mass Index).
In the display for calorie burn or fat burn the values can be reset by
pressing and holding SET.
Note: To increase the accuracy of the calorie and fat burn displays your
age and weight must be set correctly.
Note: The counter for fat burn is only activated while your heart rate is
above 120 beats per minute.

- 18 -
Notes on the BMI
The BMI is a statistical measurement that can be used to judge a
persons weight. For adults, a value between 18.5 and 25 is considered
normal. Values below 18.5 are considered "underweight". Values above
25 are considered "overweight". Values above 30 are considered
"Obese".
The BMI is only a coarse guideline because it does not take a persons
body type and body composition into consideration.
Heart rate (PULS/HRM)
If the chest belt is worn the current heart rate will appear on the bottom
row of the display.
Timer (TIMER)
The bottom row of the display will show the elapsed time. The value can
be reset by pressing and holding SET.
Distance (DISTANZ/DISTANCE)
The bottom row of the display will show the covered distance. The value
can be reset by pressing and holding SET.
Average speed (DURCH-GESCHW/AVG SPEED)
The bottom row of the display will show the average speed. The value
can be reset by pressing and holding SET.
Maximum speed (MAX GESCHW/MAX SPEED)
The bottom row of the display will show the maximum speed. The value
can be reset by pressing and holding SET.

- 19 -
Troubleshooting
The distance measurements are very imprecise
The watch uses the step length measured during calibration to estimate
the traveled distance.
Recalibrate the step counter. Calibrate it for walking and for running and
use extra care during the calibration.
Running on uneven surfaces may also result in bad calibration.
The heart rate is not shown or is shown incorrectly
Make sure the chest belt is positioned correctly and fits well.
Your skin should not be too dry or too cold.
The contact areas can be slightly moistened to improve function.
Electromagnetic interference may have an adverse effect on reception.
The distance between watch and chest belt must be under 60cm.
Other heart rate measuring devices within a 2m range may also cause
interference.
Wireless bicycle computers may cause interference.
The batteries may be low and require replacing.
The display is unreadable / the light does not work
Replace the batteries.

- 20 -
Disposal
Disposal of the electronic appliance
This electronic appliance may not be disposed of with normal
household waste. Dispose of the unit at an approved disposal
facility or at your local recycling centre. Please observe the
current rules and regulations when disposing of the appliance.
Contact the disposal system if in doubt.
Disposal of the batteries
Please dispose of your batteries properly in containers especially
set up at retailers. Batteries do not belong in household waste.
Dispose of the batteries at an approved disposal facility or at your
local recycling centre. Contact the disposal system if in doubt.
Replacement of battery
Battery replacements should be performed by an expert to avoid
damaging the case or gaskets.
Battery low indicator
If the battery voltage on the chest belt battery drops below the voltage
required for normal operation, "TXGURT/TXBELT" and "LO BAT/BATT"
will appear on the display. Replace the battery of the chest belt as
described in the chapter "Chest belt".