Epson XK3190-H2B - Manual (Page 12)

III Keypad Functions
I. Keys setting and keypad layout
The lower name on the key is the basic function and the function of the upper name on the key
can be executed simultaneously by pressing <shift> key.
1
COMM
2
MODE
TRANS
3
TYPE
4
TYPE
CANCEL
CALIBRAT
E
VERIFY
CONTRAST
BRIGHT
OFF ON/RES
ET
5
ACCUM
6
MEMO
RECALL
7
MEMO
CLEAR
8
TOTAL
CLEAR
WT LIMIT
SET
WT LIMIT
TARE
PRESET
TARE WT
DELETE
EXIT
ENTER
WEIGH
SHIFT
MODIFY
9
TIME
0
MINUS
WT
●
GW/NW DIVISION
TARE
TYPE SIGN
ZERO
LIST PR
PAPER
ROLL
MARK
PR
PRINT
II. Keys functions
Notes: <xx><xx> represent keys series and <Figure keys> represents keys operation series,
composed of <0>～<9>,<.>,<->,etc..<Shift>key perform <-> function when entering non-linearity
edited value and category mark in upper name function state. In other cases, serve as switch between
the upper name function and lower name function states.
1. <<On/ Reset>> Power on and reset. Self-checking begins upon powering on and then go to
weighing display mode. The displayed value zeroed if the difference between present
weight and preset zero point is within initial zero-setting range and the automatic
zero-setting switch is on (p29=1), if without , <Err 50> appears and the last zero point
remains.
2. <<Off>> Turn off the instrument.
3. <<Zero >> In gross weight and steady data state, this function works and present value
return to zero, provided that conforming to relevant zero-setting range. Every first
zero-setting is initial one upon powering on and zero-setting range is determined by P16
with 20(% Max) as default. After zero-setting, zero-setting range become ±2%Max of
initial zero point.
4. <<GW/NW>>Switching between gross weight and net weight, tare data remains.
5. <<Tare>> In gross weight and steady data state, tare the present value and then go to net
weight state.
6. <<Shift>><<Division>><<Figure Key>><<Enter>> Set division d, resume previous
calibrated division after powering off.
7. <<Shift>><<Type sign>><<Figure Key>><<Enter>> A figure with any decimal digit
and minus can be set to identify the category of present goods. This category mark can be
printed by external printer only and internal printer can not print this category mark. Press
<<Shift>><<Type sign>>to check category marks during operation.
8. <<PR>> Print present data. If present data is weight with category mark, it will be saved
to weighing record and added into accumulation value. Only the displayed information