Sealey VSE300D - Manual

INSTRUCTIONS FOR:
PETROL ENGINE COMPRESSION
TESTER KIT
MODEL No:
VSE300D
1. SAFETY INSTRuCTIONS
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRuCTIONS CAREFuLLY. NOTE THE SAFE OPERATIONAL REQuIREMENTS,
WARNINGS AND CAuTIONS. uSE THE PRODuCT CORRECTLY AND WITH CARE FOR THE PuRPOSE FOR WHICH IT IS
INTENDED. FAILuRE TO DO SO MAY CAuSE DAMAGE AND/OR PERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRuCTIONS SAFE FOR FuTuRE uSE.
2. INTRODuCTION
VSE300D Issue No: 1 - 05/01/11
 WARNING! Ensure all Health and Safety, local authority and general workshop practice regulations are adhered to when using these tools.
 DO NOT use tools if seals or threads are damaged. Any defective seal MuST be changed before use to avoid incorrect readings.
 Maintain the tools in a good, clean condition for best and safest performance.
 Ensure that a vehicle that has been jacked up is adequately supported with axle stands.
 Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging, tie back long hair and DO NOT wear jewellery.
 Ensure any disconnected fuel pipes are plugged to avoid spillage.
 Ensure that the correct connector is used for the engine/vehicle being tested.
 Always release the pressure from the gauge before disconnecting the quick release coupling.
 Account for all tools, and parts being used and DO NOT leave them in or near the engine.
 WARNING! Select neutral (or ‘park’ if automatic transmission) and keep hands clear of the engine as engine rotation may occur when using
these tools. The ignition MuST BE turned off, and only switched on when instructed to do so.
s IMPORTANT: Always refer to the vehicle manufacturer’s service instructions, or a proprietary manual, to establish the current procedure and data.
These instructions are provided as a guide only.
 When not in use, return all parts to the protective case and store this in a safe, dry, childproof location.
 WARNING! The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations that may
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by the
operator.
Features 300psi gauge with large rubber bumper. Includes extension for deep seated plugs and flexible extension hose. Suitable for petrol engines
with 10, 12, 14 and 18mm spark plug threads.
Original Language Version