Powerfix Z30943A - Manual (Page 26)

28 GB/MT
Safety advice / Installation
Attach the product to a wall through the 8 screw holes
in the aluminium rail.
Do not attach the product to a wall if it is less than
15 mm thick.
Installation
CAUTION! RISK OF INJURY! Refer to the operat-
ing instructions for your electric drill.
Note: In the case of a masonry wall, use an ø 8 mm drill
bit. For plaster use a ø 6 mm drill bit.
Note: No dowels
5 are necessary for attaching the
product to a wooden wall. Screw in the screws 6 directly
into the wall.
Mark the positions of the holes with the help of a
spirit level in the desired place on the wall (see Fig. B).
Drill the holes with an appropriate drill bit and insert
the dowels 5 into the drilled holes (see Figs. C, D).
Hold the aluminium rail 4 in position at the desired
place on the wall and screw the screws 6 through
the screw holes 3 into the dowels 5 (see Fig. E).
Ensure that the aluminium rail 4 is attached the right
way up on to the wall. The U-shaped recess 2 must
face upwards (see Fig. F).
Now suspend the hooks 1 in the U-shaped recess 2 .
When doing this, press the hooks 1 so that they en-
gage in the aluminium rail 4 (see Fig. F).
66777_pow_Ordnungs-System_Content_LB5.indd 28 22.06.11 09:22