Epson WorkForce DS-860 - Manual (Page 38)

Maintenance
Cleaning the Product
To keep your product operating at its best, follow the steps below to clean it periodically.
c Important:
❏ Never use alcohol, thinner, or corrosive solvent to clean the product. These chemicals can damage the product
components and the case.
❏ Be careful not to spill liquid into the product mechanism or electronic components. This could permanently
damage the mechanism and circuitry.
❏ Do not spray lubricants to the product.
❏ Never open the product case.
A
Turn off the product.
B
Unplug the AC adapter from the product.
C
Wipe off any dirt on the outer case with a soft cloth.
Note:
If the case is very dirty, dampen a soft cloth with water and wring it well, and then wipe off any remaining stains.
After that, use a soft dry cloth to wipe the case.
Cleaning inside the scanner
When scanned images have streaks or when scanned documents become dirty, clean inside the scanner.
c Important:
❏ Do not place too much force on the glass surface inside the product.
❏ Be careful not to scratch or damage the glass surface inside the product, and do not use a hard or abrasive brush to
clean it. A damaged glass surface can decrease the scan quality.
❏ Never use alcohol, thinner, or corrosive solvent to clean the scanner. These chemicals can damage the scanner
components and the case.
❏ Be careful not to spill liquid into the scanner mechanism or electronic components. This could permanently
damage the mechanism and circuitry.
❏ Do not spray lubricants inside the scanner.
A
Turn off the product.
DS-860 User’s Guide
Maintenance
38