Marshall Electronics CV342-CSB / CS - Manual (Page 13)

13
1080 HD-SDI Camera
MAIN MENU
1. LENS
2. EXPOSURE
3. BACK LIGHT
4. WHITE BAL
5. DAY & NIGHT
6. NR
7. SPECIAL
8. ADJUST
9. RESET
10. EXIT
DC
BLC
MANUAL
AUTO
WHTE BALANCE
MANUAL WB
1. BLUE IIIIIIIIIIIII50
2. RED IIIIIIIIIIIII50
3. RETURN RET
Select WHITE BALANCE using the UP or DOWN button.
You can change the white balance mode between ATW, AWC SET, INDOOR, OUTDOOR, AWB,
or MANUAL using the LEFT or RIGHT button.
ATW (Auto Trace White Balance): continuously adjusts camera color balance in
accordance with any change in color temperature. compensates for color temperature
changes within the range of 2000K to 10000K.
AWC SET: The white balance is automatically adjusted in a specific luminance
environment. To find the optimal luminance level for the current environment, point
the camera towards a shoot of white paper and press the SET button.
INDOOR: Select this when the color temperature is between 4,500˚K and 8,500˚K.
OUTDOOR: Select this when the color temperature is between 1,700˚K and 11,000˚K.
(Ex. sodium light inclusion)
AWB (Auto White Balance): controls the automatic adjustment of the light source’s
color temperature.
MANUAL: Select this to fine-tune White Balance manually.
You can adjust the blue and red tone level manually.
BLUE: Adjust the blue tone of the image. (0~100)
RED: Adjust the red tone of the image. (0~100)
■ Set White Balance first by using the ATW or AWB mode. After that switch to MANUAL mode,
■ White Balance may not work properly under the following conditions. In this case, select the AWC mode.
- When the ambient illumination of the subject is dim.
- If the camera is directed towards a fluorescent light or is installed in place where illumination changes
dramatically, the White Balance operation may become unstable.