MEDC Weatherproof ResistTel IP - Manual (Page 18)

Page 18 Short Manual ResistTel IP2 / IP152
ExResistTel IP2 / IP154
The LAN-lead wire has to be connected to the connector in the front. Die LAN1 lead
wire can to be with PoE (Power over Ethernet). Alternatively the phone can be
supplied with power external.
The second LAN connector of the ResistTel IP2 / IP152 doesn’t support PoE. Also it
can’t be used to connect a phone directly, which should be powered with PoE.
All not used cable feed through have to be closed with sealing plugs.
1.5.2
External Power Supply Connection
An external power supply can be adapted to the terminals 5 (+) and 6 (-). The
voltage has to be:
 Without using the optional voltaic separated inputs: 15 V – 57 V DC, 13 W
 With using the optional voltaic separated inputs: 21,5 V – 57 V DC, 13 W
If the external power connection will be used, you must not use PoE at the LAN
connection.
1.5.3
Relay Connection
The phone can be build up with a relay module with two relays with a single
changeover switch optional.
The maximal breaking capacity of a relay is depending on the voltage:
• 240 V, 6 A, AC
• 24 V, 6 A, DC
• 32 V, 5 A, DC
• 48 V, 1 A, DC