MEDC Weatherproof ResistTel IP - Manual (Page 28)

Page 28 Short Manual ResistTel IP2 / IP152
ExResistTel IP2 / IP154
3. To finish a call respectively to the active operating mode:
• Put the handset back on its rest (handset mode).
• Press the key
(All modes).
• Press the loudspeaker key
(hands free mode).
• Press the headset key (Key
long (longer than a second) and then the
loudspeaker key ) (headset mode).
2.3.3.2 Block Dialling
For block dialling do the following steps:
1. Let the handset on its rest and don’t activate the hands free or headset mode.
2. Enter the phone number completely.
3. When entering the telephone number, you may edit already entered digits. Use
the and keys to move the cursor, and the key to delete the digit to the
left of the cursor.
4. Respectively to the wanted calling mode, you can setup the call as follows. In this
matter, it will be dialled after one of the following activities.
a. Lift off the handset (handset mode).
b. Press the loudspeaker key (hands free mode).
c. Press the headset key (Key long (longer than a second) and then the
loudspeaker key ) (headset mode).
d. Press the key or key (short or long). With a configured headset
you will reach the headset mode otherwise the hands free mode.
e. Using the key (short or long) executes the selection immediately.
Using the key , however, executes the selection only if the cursor is
situated to the right of the last entered digit.
5. When using block dialling, you may enter further properties of the selection. Do
so by pressing the key. See chapter 2.3.3.2.1 on page 29.