Edelbrock 3530 User Manual
Page 3
3
Pro-Flo EFI Installation Instructions
©2005 Edelbrock Corporation
Rev. 2/05
Brochure #63-0273
Catalog #3530 & #3531
TOOLS AND EQUIPMENT
Use the following checklist for items needed.
❑ Box and open end wrenches
❑ Socket set
❑ Distributor wrench
❑ Pliers (channel locks and hose clamp)
❑ Screwdrivers (regular and Phillips)
❑ Torque wrench
❑ Hammer
❑ Gasket scraper or putty knife
❑ Timing light
❑ Vacuum gauge
❑ Rags
❑ Water bucket
❑ Harmonic balancer puller
❑ Dial indicator
❑ Drill and bits
❑ Hole saw (1 1/4-inch or 1 3/4-inch)
❑ Tubing wrenches
❑ Tubing cutter
P R E L I M I N A RY C H E C K L I S T
1.
CAREFULLY STUDY AND UNDERSTAND ALL INSTRUCTIONS, BEFORE BEGINNING THIS INSTALLATION.
NOTE: This installation can be accomplished using common tools and procedures. However, you should have a
basic knowledge of automotive repair and modification and be familiar with and comfortable working on your
vehicle. If you do not feel comfortable working on your vehicle, it is recommended to have the installation
completed by a professional mechanic.
2.
Examine the Pro-Flo system for possible shipping damage. If damaged, contact your dealer immediately.
3.
The 3530 & 3531 kits are designed for use with a standard AMC V8 firing order.
4.
Check all threaded manifold holes.
5.
Check all internal manifold passages with a light and wire, making sure they are clean and unobstructed.
6.
Check automatic transmission shift points before removal of your stock manifold and adjust linkage after
Edelbrock manifold installation for same shift points (if needed).
NOTE::
We recommend that you refer to this checklist again after installation to be sure that you have completed all
steps.
HARDWARE AND PARTS RECOMMENDED
❑ Intake gasket - Fel-Pro #MS96011 or OEM steel gasket ONLY
❑ Pipe plugs, if needed
❑ 5/16-inch steel tubing (approximate equal length to fuel
pickup line in tank)
❑ Loctite 598 OEM High Temperature Silicone Gasket
(O
2
Sensor Compatible)
❑ Radiator coolant
❑ Teflon tape
❑ Wiring diagram for your vehicle
❑ Intake Manifold Bolt kit #8534
❑ Spark plug wire set that will accept male towers on the
distributor, unlike factory female plug wire towers.
❑ 195° Thermostat
❑ Resistor type spark plugs (Use the correct heat range for
your particular application)