Edelbrock 3530 - Manual (Page 32)

32
Pro-Flo EFI Installation Instructions ©2005 Edelbrock Corporation
Rev. 2/05
Brochure #63-0273
Catalog #3530 & #3531
Check Qty. Description
1 Manifold Assembly ( as seen below)
1 Installation Instructions
1 EFI Owner’s Manual
1 Basic ECU
1 Fuel Filter
1 Manifold Air Temperature Sensor
and Grommet
1 Fuel Pump
1 Cal. Module
1 Cal. Module Cord
1 Cord Adapter
1 Distributor
1 Ignition Amplifier
1 Main Wire Harness
1 Fuel Pump Harness
1 Fuel Pump Relay
1 20 Amp Fuse (installed in Harness)
P R O - F L O M U LT I - P O I N T E F I
#3530 & #3531
KIT CONTENTS
MANIFOLD ASSEMBLY CONTENTS
(SHIPPED ASSEMBLED)
Check Qty. Description
2 5/16” Fuel Line Hose Clamps HP
5 3/8” Fuel Line Hose Clamps
1 AN #6 45 Deg. Elbow Push Lock
1 1/4” In X1/4” Out X 5/32” Vacuum Tee
15’ 3/8” Push Lock Fuel Line
15” 11/32” PCV Hose
15’ 5/16” Rubber Return line Hose
(fuel Safe)
1 Fuel Filter Adel Mounting Clamp
12 Tek screws 10-16 x 3/4”
3 Tek screws 1/4-14 x 3/4”
1 PCV Valve
14 11” Tie Wraps
1 O/2 Sensor
1 O/2 Sensor Weld In Bung
1 Coolant Temp. Sensor (3509 only)
1 Fuel Pump Block Off Plate
1 3 Amp Fuse (installed in Harness)
Check Qty. Description
1 Intake Manifold
1 7/32” Vacuum Hose
1 Coolant Temp. Sensor (3526 only)
1 MAP Sensor Assembly
8 Electronic Fuel Injectors – Pico
1 5/32” Vacuum Hose 6”
1 7/32” Vacuum Hose 8”
1 Passenger Side Fuel Rail
1 Driver Side Fuel Rail
1 Fuel Pressure Regulator
1 Assembled 4 Barrel Throttle Body
4 1/4” Star Washer
4 5/16” Internal Start Washer
1 Viton O-Ring
1 3/8” Pipe Plug
Check Qty. Description
1 Fuel Inlet Fitting
(3/8” NPT Male To #6 AN Male)
1 1/4” In To 1/4” Out X 5/32”
Bottom Out Vacuum “T” Fitting
1 1/4” NPT To 1/4” Hose Barb, Brass
1 Throttle Body Gasket
1 Fuel Crossover line With 45-Deg. End
(Includes Schrader Valve & Cap)
1 1/4”-20 X 1/2” Hex Head Cap Screw
4 1/4” -20 X 1.25” Long Hex Head
Cap Screw”
1 Fuel Regulator Nut
4 1/4” ID. SAE Flat Washer
1 1/4” ID. Split Lock Washer
4 5/16” Hex Nut
4 5/16 X 1-3/8” Carb Studs