RISCO Group ProSYS, Interactive Voice Module - Manual (Page 15)

Voice Module Programming and Operations Manual
15
To record a UO message:
1.
VOICE MESSAGE:
1) MSG. STRUCTURE
VOICE MESSAGE:
1) MSG. STRUCTURE
From the Voice Message menu , select [2]
Play/Record .
2.
PLAY/RECORD:
1) COMMON MSG.
PLAY/RECORD:
1) COMMON MSG.
Select [4] UO Message .
3.
UO MESSAGE:
1) UO MESSAGE 1
UO MESSAGE:
1) UO MESSAGE 1
Each option in the UO Message menu
represents a message for a utility output.
Select the number representing the message to which you want
to assign an appliance.
4.
CHOOSE UO:
02) OUTPUT 03
CHOOSE UO:
02) OUTPUT 03
The options in the Choose UO menu represent
your Follow Code home appliances. Ask your
installer about defining appliances as Follow
Code .
Select the number representing the appropriate appliance for the
message selected in step 3.
-OR-
Select 00 for no appliance to be assigned to a message.
=
NOTE:
All 8 appliances are assigned to
00
by default. When remotely operating appliances
using the
Operations
menu, appliances are not announced unless an option other than
00
is assigned to them in this step.
5.
OUTPUT 03
01) PLAY MESSAGE
OUTPUT 03
01) PLAY MESSAGE
Select [02] Record Msg .
6.
PRESS # TO START
MESSAGE RECORD
PRESS # TO START
MESSAGE RECORD
Press /
==
and say your message into
the appropriate microphone.
=
NOTE:
A microphone is located in both the Voice Module and in each MBU. Ask your installer
which microphone should be used for recording messages.
7.
PRESS # TO STOP
REC. TIME: 02
PRESS # TO STOP
REC. TIME:
PRESS # TO STOP
REC. TIME: 02
PRESS # TO STOP
REC. TIME:
The counter in the bottom right of the LCD
counts down the seconds remaining until the
system stops recording.
Recording stops automatically after 2 seconds. If you finish your
message in less than 2 seconds, press to stop recording.
=
TIP:
After recording, you can verify that you have assigned the correct appliance to the
selected recording by repeating this procedure and selecting
[1] Play Msg.
in step 5. If
you use the
[1] Play Msg.
option before recording your own message, you hear the
default system message for the appliance, such as
utility output 1
.