Rosen Aviation 0602 Series : Dual Blu-ray Player - Manual (Page 21)

Rosen Aviation Dual Blu-ray DVD Player
Document Number: 104185 Revision: D
Date: 05/28/15
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 21 of 41
CEC Support
Consumer Electronics Control (CEC) supports status messages for the
device.
This feature is currently not implemented.
Restore Factory
Defaults
Restores the unit to the factory default settings. Choose Ok or Cancel at
the prompt.
 Ok: Restores the factory defaults and closes the pop-up window.
 Cancel: Closes the pop-up window without resetting the factory
defaults.
Note: Factory defaults are different to each model and depend on
whether the unit is connected to an HDMI monitor.
Activate Device (or
De-activate Device
if device is
activated)
This feature is reserved for future use.
7.1.2. Network Submenu
When you select the Network, the Dual Blu-ray player initiates a network test and
displays the test results in a summary window. All fields are read-only unless you change
the IP Mode options. Select SettingsNetwork and then press ENTER to open the
window, as shown below.
Figure 12 Network submenu showing the test summary
Network Test
Summary
 Link Status
 MAC Address
 IP Mode submenu
 IP Address
 Subnet Mask
 Gateway
 Primary DNS
 Secondary DNS
 Network Test