TA Triumph-Adler P-4030D - Manual (Page 131)

4-71
Operation Panel
2
Press [OK]. The AppleTalk screen appears.
3
Press  or  to select whether AppleTalk is enabled.
4
Press [OK]. The AppleTalk setting is set and the Basic menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the standard by the IETF for authentication and encryption in
the third network layer (IP layer).
It can be used with both IPv4 and IPv6.
1
In the Basic menu, press  or  to select IPSec.
2
Press [OK]. The IPSec screen appears.
3
Press  or  to select whether IPSec is enabled.
4
Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting is Auto.
1
In the Basic menu, press  or  to select LAN Interface.
2
Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
3
Press  or  to select the desired LAN Interface.
4
Press [OK]. The LAN Interface is set and the Basic menu
reappears.
AppleTalk: a b
1 Off
********************-
2 *On
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP addresses.
IPSec: a b
********************-
2 On 1 *Off
Note LAN Interface is only displayed when the optional network interface kit (IB-50) is installed.
LAN Interface: a b
********************-
2 10Base-Half
3 10Base-Full 1 *Auto