Whelen P46SLCHG - Manual (Page 2)

Page 2
Red (+)
To +VBAT
Fuse @5A
Black (-)
To Ground
5/16-18 X 2 1/4"
Hex Head Bolt
5/16-18 X 1 1/4"
Carriage Bolt
PAR-46
Work Light
5/16 Flat Washer
Mounting
Bracket
5/16 Elastic Stop Nut
5/16 Elastic Stop Nut
Installation:
1. Drill a 3/8” mounting hole and insert the mounting bolt through
the mounting bracket and into the mounting hole.
2. Secure the mounting bracket with the supplied elastic stop nut
and flat washer as shown.
3. Extend the RED wire to a switched 12V power source (fuse @ 5
amp). Extend the BLACK wire to chassis ground.
WARNING! All customer supplied wires that connect to the
positive terminal of the battery must be sized to supply at least
125% of the maximum operating current and FUSED at the
battery to carry that load. DO NOT USE CIRCUIT BREAKERS
WITH THIS PRODUCT!
Caution:Permanent mounting of this product requires drilling.
Make sure that no other vehicle components could be damaged
by this process. Check both sides of the mounting surface
before starting. If damage is likely, select a different mounting
location.
IMPORTANT! It is the responsibility of the installation
technician to make sure that the installation and operation of
this product will not interfere with or compromise the operation
or efficiency of any vehicle equipment! Before returning the
vehicle to active service, visually confirm the proper operation
of this product, as well as all vehicle components/equipment.
CAUTION! DO NOT LOOK DIRECTLY AT THESE LEDS WHILE THEY ARE ON.
MOMENTARY BLINDNESS AND/OR EYE DAMAGE COULD RESULT!
IMPORTANT WARNING!