Whelen RBKTHD1 - Manual

Page 1
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Bracket
Acorn Nut Fig. 1
Lighthead
Flange
6-32 X 1/2"
PPHMS SS
Installation:
This bracket will install on either side of the front fork of
the motorcycle. You will use the bolts that hold the
windshield bracket on. This manual shows the Road
King. If you have the Electra-Glide, installation is the
same, except you will have Torx head bolts instead of
acorn nuts.
Automotive:
Li
ghtheads
Installation Guide:
TIR3™ Super LED® Lighthead Bracket Model RBKTHD1
Side Cowl Mount, Harley-Davidson® w/State Police Package
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
1. Install the lighthead onto the bracket as shown.
2. Remove the 2 acorn nuts that secure the front spot bracket to the motorcycle (do not remove the bracket).
3. Mount the bracket (with lighthead and flange) onto the motorcycle and then reinstall the acorn nuts to secure the bracket in place.
4. Extend the lighthead wires to your power source and refer to the lighthead manual for hookup and operation.
©2004 Whelen Engineering Company Inc.
Form No.13932B (060707)
For warranty information regarding this product, visit www.whelen.com/warranty
51 Winthrop Road,
Chester, Connecticut 06412-0684
Phone: (860) 526-9504
Fax: (860) 526-4078
Bracket
Acorn Nut Fig. 1
Lighthead
Flange
6-32 X 1/2"
PPHMS SS
Installation:
This bracket will install on either side of the front fork of
the motorcycle. You will use the bolts that hold the
windshield bracket on. This manual shows the Road
King. If you have the Electra-Glide, installation is the
same, except you will have Torx head bolts instead of
acorn nuts.
Automot
ive:
Li
ghtheads
Installation Guide:
TIR3™ Super LED® Lighthead Bracket Model RBKTHD1
Side Cowl Mount, Harley-Davidson® w/State Police Package
®
ENGINEERING COMPANY INC.
Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]
1. Install the lighthead onto the bracket as shown.
2. Remove the 2 acorn nuts that secure the front spot bracket to the motorcycle (do not remove the bracket).
3. Mount the bracket (with lighthead and flange) onto the motorcycle and then reinstall the acorn nuts to secure the bracket in place.
4. Extend the lighthead wires to your power source and refer to the lighthead manual for hookup and operation.
©2004 Whelen Engineering Company Inc.
Form No.13932B (060707)
For warranty information regarding this product, visit www.whelen.com/warranty