Whelen RBKT1 User Manual

Automotive: li ghtheads, Automot ive: li ghtheads

Advertising

Page 1

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

Fig. 1

INSTALL

HERE

Installation:

This bracket can mount to many different vehicles. This manual will
cover mounting to a Ford Crown Victoria.

1. Open the hood and find the mounting area located just in front of the

vehicles horns as shown in Fig. 1. NOTE: While not essential,
removing the vehicle grill (following vehicle manufacturers
instructions) will make the installation easier. Place the bracket
onto the mounting surface in the exact mounting location. Mark off
(onto the mounting surface) the location of the mounting holes, then
remove the bracket and drill the mounting holes with an
appropriately sized drill for the hardware.

Automotive:

ghtheads

Installation Guide:

TIR3™ Lighthead Mounting Bracket

Model RBKT1, RBKT2

ENGINEERING COMPANY INC.

Internet: www.whelen.com
Sales e-mail: [email protected]
Canadian Sales e-mail: [email protected]
Customer Service e-mail: [email protected]

NOTE: Model RBKT1 (single bracket) is
shown for example. Model RBKT2 (double
bracket), mounts the same way.

For warranty information regarding this product, visit www.whelen.com/warranty

2. Secure the lighthead to the bracket as

shown on the next page.

3. Secure the bracket to the vehicle using the

supplied mounting hardware.

4. Extend the lighthead wires to your power

source and refer to the lighthead manual
for wiring.