Whelen SAK32 - Manual (Page 2)

Page 2
wire
exit &
drain
hole
SA315 / Rear View
IMPORTANT: For drainage purposes, the
speaker must be oriented so that the wire
passage hole is in the “6 o’clock” position
(closest to the road). This is also the drain
hole for the siren. Improper mounting will
result in premature driver failure and void
the product warranty.
Fig. 3
DRIVER SIDE PASSENGER SIDE
EXISTING
BOLT
EXISTING
BOLT
EXISTING
BOLT
1/4-20 ELASTIC
STOP NUT
1/4-20 X 1" HEX
HD CAP SCREW
SPEAKER SPEAKER
wire passage
/drain hole
1/4 - 20 X 1-1/4"
HEX HEAD SS
SA315
1/4 X 20 X 1-1/4
HEX HEAD
1/4" SPLIT
LOCK WASHER
1/4" SPLIT
LOCK WASHER
Fig. 4
Installation:
1. Following manufacturers instructions remove the front grill from
the vehicle (Fig. 1).
2. The speaker will mount behind the grill in the area indicated (Fig.
2). Remove the 2 existing bolts from the vehicle (Fig. 3) that you
will use to mount the bracket.
3. Mount the bracket to the siren speaker (Fig. 4).
4. Mount the bracket (with speaker) to the vehicle using the hardware
shown (see drain hole information).
5. Extend the BLACK (-) negative and WHITE (+) positive speaker
wires to your siren amplifier and connect as described in the
instructions that come with the siren amplifier.
6. Replace the vehicle grill then test the siren speaker and the
speaker installation is complete.
IMPORTANT: It is the responsibility of the installation technician to
make sure that the installation and operation of this product will not
interfere with or compromise the operation or efficiency of any
vehicle equipment!
IMPORTANT! Before returning the vehicle to active service, confirm
the proper operation of this product, as well as all vehicle
components/equipment.
Fig. 1 Fig. 2