Epson 4SLC2-50 - Manual (Page 118)

AT Command Summary (continued)
Command Description
Sr? Reads value stored in r
Sr=n Sets register r to n
V0 Returns result codes as numbers
V I Returns result codes as words
X0 Enables basic result codes (0-4)
I
X1 Enables extended result codes (0-5, 10)
I
X2 Enables extended result codes (0-6, 10)
X3 Enables extended result codes (0-5, 7, 10)
X4 Enables all result codes
Y0 Disable long space disconnect
Y1 Enable long space disconnect
Z0 Software reset; recalls user configuration O
I
Z1 Software reset; recalls user configuration 1
I
&C0 DCD signal always on
I
&C1 DCD signal on when carrier present
&D0 Ignore DTR signal
&D1 Returns to command mode when an on-to-off DTR
transition occurs
&D2 Hangs up and returns to command mode when an
on-to-off DTR transition occurs
&D3 Resets when an on-to-off DTR transition occurs
&F Loads factory configuration settings
&G0 No guard tone in CCITT mode
&G1 550 Hz guard tone in CCITT mode
&G2 1800 Hz guard tone in CClTT mode
I
&P0 Pulse dial make/break ratio = 39%/61% (US.)
&P1 Pulse dial make/break ratio = 33%/67% (UK.)
Fax/Modem B-5