Amprobe HD160C Digital-Multimeter - Manual (Page 21)

15
meter face down on a clean padded surface. Lift off cover and carefully remove the fuse by
gently prying under the fuse. Pry out the large fuse by placing a small flat screwdriver under the
fuse’s center using the circuit board edge toward the bottom of the meter as a fulcrum. Do NOT
use the gasket as a fulcrum point as this could permanently disfigure the gasket.
�� Warning
Use only the same size and type fuse specified. Use of higher amperage or lower voltage or different type fuses could result in
shock, injury and/or damage to the meter. Replacement fuse is:
2 A/1500 V fast blow ceramic size 8 x 65 mm. Amprobe  p/n: FP700.
CLOSING THE BATTERY COMPARTMENT
After fuse replacement, replace the fuse cover and the rear case cover; be careful not to
bend or pinch the case rim gasket. Re-install the six hex-head screws with a gasket and
washer and tighten securely with an even amount of torque on each. Do NOT over tighten
as this may strip case threading. Turn on the meter and test operation. If working normally
replace the holster.
Repair Information
All test tools returned for warranty or non-warranty repair or for calibration should be accompanied
by the following: your name, company’s name, address, telephone number, and proof of purchase.
Additionally, please include a brief description of the problem or the service requested and include
the test leads with the meter. Non-warranty repair or replacement charges should be remitted in the
form of a check, a money order, credit card with expiration date, or a purchase order made payable to
Amprobe Test Tools.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement and check your battery before requesting repair. During the
warranty period any defective test tool can be returned to your Amprobe Test Tools distributor for an
exchange for the same or like product. Please check the “Where to Buy” section on www.amprobe.com
for a list of distributors near you. Additionally, in the United States and Canada In-Warranty repair and
replacement units can also be sent to an Amprobe Test Tools Service Center (see below for address).
Non-Warranty Repairs and Replacement – US and Canada
Non-warranty repairs in the United States and Canada should be sent to an Amprobe Test Tools
Service Center. Call Amprobe Test Tools or inquire at your point of purchase for current repair and
replacement rates.
In USA In Canada
Amprobe Test Tools Amprobe Test Tools
Everett, WA 98203 Mississauga, ON L4Z 1X9
Tel: 877-AMPROBE (267-7623) Tel: 905-890-7600
Non-Warranty Repairs and Replacement – Europe
European non-warranty units can be replaced by your Amprobe

Test Tools distributor for
a nominal charge. Please check the “Where to Buy” section on www.amprobe.com for a list
of distributors near you.
European Correspondence Address*
Amprobe

Test Tools Europe
P.O. Box 1186
5602 BD Eindhoven
The Netherlands
*(Correspondence only – no repair or replacement available from this address. European customers
please contact your distributor.)