Avago Technologies 3ware SAS 9750-4i - Manual (Page 45)

Controller Object Commands
www.lsi.com/channel/products 37
/cx show autorebuild
This feature only applies to 9750 model controllers and 9000 series SX/SE/
SA model controllers.
This command shows the Auto-Rebuild policy. If the policy is enabled, the
firmware will select drives to use for rebuilding a degraded unit using the
following priority order. For more information, see “/cx set
autorebuild=on|off” on page 76.
1. Smallest usable spare.
2. Smallest usable unconfigured (available) drive.
3. Smallest usable failed drive.
If the policy is disabled, only spare drives will be used for an automatic
rebuild operation.
Example:
//localhost> /c0 show autorebuild
/c0 Auto-Rebuild Policy = on
/cx show bios
This command reports the BIOS version of controller /cx.
Example:
//localhost> /c0 show bios
/c0 BIOS Version = BG9X 2.x
/cx show carvesize
This feature only applies to 9750 model controllers and 9000 series SX/SE/
SA model controllers.
This command shows the maximum size of the volumes that will be created if
the autocarve policy is set to on. The carvesize can be set between 1024 GB
and 32768 GB (1 TB to 32 TB). Default carvesize is 2048 GB (2 TB). For
more information see, “/cx show autocarve” above.
Example:
//localhost> /c0 show carvesize
/c0 Auto-Carving Size = 2000 GB