Avago Technologies 3ware SAS 9750-4i - Manual (Page 75)

Controller Object Commands
www.lsi.com/channel/products 67
/c x add selftest= ddd:hh
This command adds a new task slot to the Selftest Task Schedule on the day
ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh
(range 0 .. 23). Notice that selftest runs to completion and as such no duration
is provided. A maximum of seven selftest task slots can be included in the
schedule. This command will fail if no (empty) task slot is available.
In order to run at the specified times, selftests must be enabled, using the
command “/cx set selftest=enable|disable [task=UDMA|SMART]” on
page 74.
Note: Adding self tests to the schedule is different from adding slots to the
rebuild and verify schedules. Adding a self-test directly schedules the test, as
well as defining a time slot during which the task can occur.
Example:
//localhost> /c1 add selftest=Sun:16
Adding scheduled verify to slot 7 for [Sun, 4:00PM] ... Done.
In this example, a selftest background task is scheduled to be executed on
Sundays at 16 hours (4:00 PM).
Setting Up a Selftest Schedule
Setting up a selftest schedule requires several steps, and several different CLI
commands in addition to /cx add selftest.
To set up the selftest schedule you want to use, follow this
process:
1 Use the /cx show selftest command to display the current schedule for
selftest tasks. (For details, see page 64.)
2 If any of the scheduled tasks do not match your desired schedule, use
the /cx del selftest command to remove them. (For details, see page 68.)
3 Use the /cx add selftest command to create the selftest schedule slots you
want (described above.)
4 Use the /cx set selftest=enable command to enable the schedule (this
enables all selftest schedule slots). (For details, see page 74.)
/c x del rebuild= slot_id
This command removes the rebuild background task slot slot_id from the
Rebuild Task Schedule.
Example :
//localhost> /c1 del rebuild=2
removes the rebuild background task in slot 2.