Avago Technologies 3ware SAS 9750-4i - Manual (Page 52)

Chapter 2. CLI Syntax Reference
44 3ware SATA+SAS RAID Controller Card CLI Guide, Version 10.0
/cx show pcb
This command reports the PCB (Printed Circuit Board) version of the
specified controller /cx.
Example:
//localhost> /c0 show pcb
/c0 PCB Version = RevX
/cx show pchip
This command reports the PCHIP (PCI Interface Chip) version of the
specified controller /cx.
Example:
//localhost> /c0 show pchip
/c0 PCHIP Version = 1.x
/cx show serial
This command reports the serial number of the specified controller /cx.
Example:
//localhost> /c0 show serial
/c0 Serial Number = F12705A3240009
/cx show spinup
This feature only applies to 9000 series controllers.
This command reports the number of concurrent SAS and SATA disks that
will spin up when the system is powered on, after waiting for the number of
seconds specified with the
set stagger command. Spinup does not work
with SAS or SATA disks attached to an expander.
Example:
//localhost> /c0 show spinup
/c0 Disk Spinup Policy = 1
/cx show stagger
This feature only applies to 9000 series controllers.
This command reports the time delay between each group of spinups at the
power on. Spinup does not work with SAS or SATA disks attached to an
expander.
Example :
//localhost> /c0 show stagger
/c0 Spinup Stagger Time Policy (sec) = 2